| 基于体硅工艺的静电致动微夹持器制作工艺分析 |
| |
| 引用本文： | 李勇,李玉和,李庆祥,訾艳阳.基于体硅工艺的静电致动微夹持器制作工艺分析[J].光学精密工程,2003,11(2):109-113. |
| |
| 作者姓名： | 李勇 李玉和 李庆祥 訾艳阳 |
| |
| 作者单位： | 清华大学,精密仪器与机械学系,北京,100084 |
| |
| 基金项目： | 清华大学机械工程学院985研究基金 |
| |
| 摘 要： | 介绍了一种基于体硅工艺的大尺寸、大深宽比梳状静电致动微夹持器的制作工艺。对微夹持器制作中的关键工艺进行分析,重点分析ICP蚀刻工艺的蚀刻时间对结构的影响,总结导致器件失效的原因,探讨了减少失效的方法。加工过程中采用分步加工的办法控制蚀刻时间,成功的释放了宽6μm,厚60μm,等效长度达5470μm的悬臂梁型微夹持臂。研制出一种良好性能的具有S形柔性结构夹持臂的梳状静电致动微夹持器。
|
| 关 键 词： | 体硅工艺 电感耦合等离子体 蚀刻 微夹持器 |
| 文章编号： | 1004-924X(2003)02-0109-05 |
| 收稿时间： | 2002/11/12 |
| 修稿时间： | 2002年11月12 |
Fabrication process analysis for electrostatically actuated microgripper based on silicon bulk micromachining |
| |
| LI Yong,LI Yu_he,LI Qing_xiang,ZI Yan_yang.Fabrication process analysis for electrostatically actuated microgripper based on silicon bulk micromachining[J].Optics and Precision Engineering,2003,11(2):109-113. |
| |
| Authors: | LI Yong LI Yu_he LI Qing_xiang ZI Yan_yang |
| |
| Affiliation: | Department of Precision Instruments and Mechanology, Tsinghua University, Beijing 100084, China |
| |
| Abstract: | The fabrication process of a comb-drive electrostatically actuated microgripper based on silicon bulk micromachining is described in detail, with the effect of ICP etch time on structure analysed. Some factors causing microgripper failure identified, and advices provided for avoidance of failure. With a fractional ICP etch method used to control the etch time a gripper finger of 6 μm wide and 5 470 μm high was successfully released. A high aspect ratio microgripper with S-shaped flexible fingers has been developed. |
| |
| Keywords: | silicon bulk micromachining ICP(Inductance coupling plasma) microgripper |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
| 点击此处可从《光学精密工程》浏览原始摘要信息 |
|
点击此处可从《光学精密工程》下载全文 |
|
