Infrared Absorption Spectra of Cellulose Pulps of Palm Tree

Palm leaves are used for the production of different cellulose pulps; their properties are investigated, the resulting pulps were bleached by a multistage process, the effects of the addition of solvent during the pulping process on the chemical structure of the pulps are discussed. The strength properties of the paper which is produced from unbleached and bleached pulps increased with increasing cellulose percentage and decreasing lignin content in the pulp. Infrared absorption spectra were recorded for different unbleached and bleached pulp in the frequency range 200–4000 cm^-1 by using the alkali halide disk technique; the factors which affect the experimental technique were calibrated through these studies. The structural units within pulping yield (holocellulose, hemicellulose, cellulose, lignin, and ash) were interpreted within the pulp network structure by the infrared absorption spectra, where different samples of unbleached, bleached soda, and kraft pulps were also elucidated by IR spectra, after preheating at different temperatures and with using different ratios of organic solvents. The addition of organic solvents decreased or increased the crystallinity indices, depending on the type of solvent and the pulping temperature. It was also found that, at the same pulping temperature (155°C) and with the same percent of organic solvents in the pulping liquor, the asymmetry indices also the mean hydrogen bonding strength (A _OH/A_CH) of the unbleached soda pulps (organosolv or nonorganosolv pulping) were less than that of unbleached kraft pulps, except for the pulps obtained by pulping with dioxan at 155°C. The mean hydrogen bond strength of the bleached pulps decreased or increased, depending on the type solvent used and the pulping temperature.