Effect of magnesium addition in low carbon steel part 2: toughness and microstructure of the simulated coarse-grained heat-affected zone |
| |
Authors: | Xiaobing Li Yi Min Chengjun Liu Maofa Jiang |
| |
Affiliation: | Key Laboratory for Ecological Metallurgy of Multimetallic Mineral (Ministry of Education), School of Materials and Metallurgy, Northeastern University, Shenyang, PR China |
| |
Abstract: | A critical investigation into the role of Mg on the toughness and microstructure of coarse grain heat-affected zone (CGHAZ) in low carbon steel has been investigated. In this research, the specimens (Mg-free and Mg-added) underwent weld thermal cycle with heat input of 54, 80, and 100?kJ?cm?1 at 1350°C peak temperature using a thermal simulator. The typical inclusions characteristics were characterised by means of scanning electron microscopy and equilibrium calculations. The precipitates were characterised by transmission electron microscopy and energy-dispersive spectroscopy. It is revealed that the occurrence of Mg in steel mostly exists in the form of Mg-Al-O oxide inclusions, but a few in the form of solid solution state and (Nb,Ti)(C,N)+MgO precipitates when the concentration of Mg is 0.0026%. The improvement of CGHAZ toughness is obtained when the heat input is 80 and 100?kJ?cm?1. The possible reasons about the effects of Mg on the toughness of CGHAZ, including Mg-Al-O inclusions, precipitates, and soluble Mg, are discussed in detail. |
| |
Keywords: | Al-deoxidised low carbon steel Mg-Al-O inclusion precipitate coarse-grained heat-affected zone (CGHAZ) acicular ferrite |
|
|