Thermoelectric Properties of Two-Phase PbTe with Indium Inclusions |
| |
Authors: | Ashoka Bali Il-Ho Kim Peter Rogl Ramesh Chandra Mallik |
| |
Affiliation: | 1. Department of Physics, Indian Institute of Science, Bangalore, 560012, Karnataka, India 2. Department of Materials Science and Engineering, Korea National University of Transportation, 50 Daehangno, Chungju, Chungbuk, 380-702, Korea 3. Institute of Physical Chemistry, University of Vienna, Vienna, Austria
|
| |
Abstract: | The thermoelectric figure of merit (zT) can be increased by introduction of additional interfaces in the bulk to reduce the thermal conductivity. In this work, PbTe with a dispersed indium (In) phase was synthesized by a matrix encapsulation technique for different In concentrations. x-Ray diffraction analysis showed single-phase PbTe with In secondary phase. Rietveld analysis did not show In substitution at either the Pb or Te site, and this was further confirmed by room-temperature Raman data. Low-magnification (~1500×) scanning electron microscopy images showed micrometer-sized In dispersed throughout the PbTe matrix, while at high magnification (150,000×) an agglomeration of PbTe particles in the hot-pressed samples could be seen. The electrical resistivity (ρ) and Seebeck coefficient (S) were measured from 300 K to 723 K. Negative Seebeck values showed all the samples to be n-type. A systematic increase in resistivity and higher Seebeck coefficient values with increasing In content indicated the role of PbTe-In interfaces in the scattering of electrons. This was further confirmed by the thermal conductivity (κ), measured from 423 K to 723 K, where a greater reduction in the electronic as compared with the lattice contribution was found for In-added samples. It was found that, despite the high lattice mismatch at the PbTe-In interface, phonons were not scattered as effectively as electrons. The highest zT obtained was 0.78 at 723 K for the sample with the lowest In content. |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|