首页 | 本学科首页   官方微博 | 高级检索  
     

基于粒子群算法的冷挤压模具结构参数优化设计
引用本文:张渝,胡启国,张甫仁.基于粒子群算法的冷挤压模具结构参数优化设计[J].中国机械工程,2010,21(8):1003-1007.
作者姓名:张渝  胡启国  张甫仁
作者单位:重庆交通大学;
基金项目:重庆市自然科学基金资助项目(2008BB3353); 重庆市教委科学技术研究项目(KJ080411)
摘    要:针对石油射孔弹挤压件,对一次挤压成形和先预挤压再终成形两种工艺进行了对比,确定了合理的工艺方案,模具结构采用预应力挤压组合凹模。采用拉丁超立方方法,分别对预挤压和终成形的组合凹模的径向直径比和过盈系数进行了抽样,应用有限元方法对抽样所得的不同结构进行数值模拟,将所得模拟结果作为响应,建立等效应力与组合凹模结构参数的Kriging模型。以降低凹模内壁最大等效应力为优化目标,分别对预挤压和终成形两个阶段的组合凹模结构参数进行了优化分析。应用Kriging模型结合粒子群算法,在结构参数的变量空间内进行全局寻优,得到了各组合凹模最佳的径向直径比和过盈系数,确定出优化的组合凹模结构尺寸,为该挤压组合凹模的设计提供了定量的优化依据。

关 键 词:null

Optimal Design of Structural Parameters of Cold Extrusion Dies Based on Particle Swarm Optimization
Zhang Yu Hu Qiguo Zhang FurenChongqing Jiaotong University,Chongqing.Optimal Design of Structural Parameters of Cold Extrusion Dies Based on Particle Swarm Optimization[J].China Mechanical Engineering,2010,21(8):1003-1007.
Authors:Zhang Yu Hu Qiguo Zhang FurenChongqing Jiaotong University  Chongqing
Affiliation:Zhang Yu Hu Qiguo Zhang FurenChongqing Jiaotong University,Chongqing,400074
Abstract:Aiming at the petroleum perforating charge shell extrusion part,the once extrusion forming process was contrasted with the pre-extrusion and final-forming process,and the reasonable process was decided using the pre-stressed combined die.The radial diameter ratio and interference coefficient of the combined die in pre-extrusion and final-forming stage were sampled.The different die structures through sampling were simulated by finite element method,and the Kriging model of effective stress and structure par...
Keywords:cold extrusion  combined die  particle swarm optimization  optimization design  
本文献已被 CNKI 等数据库收录!
点击此处可从《中国机械工程》浏览原始摘要信息
点击此处可从《中国机械工程》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号