Small-angle X-ray scattering studies on melting and recrystallization behaviors of poly(oxyethylene) crystallites in poly(d,l-lactide)/poly(oxyethylene) blends

Direct determination of the discrete distribution for crystalline lamellar thickness has been performed for poly(d,l-lactic acid)/poly(oxyethylene) (PDLLA/PEG) blends by conducting small-angle X-ray scattering (SAXS) measurements using synchrotron radiation. The PDLLA used was an random (racemic) copolymer of bio-based poly(l-lactic acid) (PLLA) and poly(d-lactic acid) (PDLA) with the lactide monomer ratio of l:d = 50:50. It is known that PLA is miscible with PEG in the amorphous state. In the current paper, we report comprehensive results on structural analyses of PDLLA/PEG blends in the course of heating and cooling process using SAXS to elucidate the change in the thickness distribution of the lamellae. As a consequence, it was found that the distribution of the lamellar thickness moves toward the larger value (in other words, lamellar thickening) as temperature approaches the melting point. Typically, the thickness distribution was dispersed in the range of 10–20 nm at room temperature and it changed toward 40 nm in the vicinity of the melting temperature. To the best of our knowledge, this is the first report of direct determination of the discrete distribution for the crystalline lamellar thickness and their in-situ changes in the course of the lamellar thickening process. As a result, the lamellar thickening was found to occur at much lower temperature for the blend samples with 10% and 20% of PDLLA contents as compared to the PEG 100% sample. This phenomenon can be ascribed to the melting point depression owing to the miscibility between PEG and PDLLA. Thereby, thinner lamellae were melted and thicker ones appeared at much lower temperature for the blends than for the PEG 100% sample. As for the average repeating distance (long period) of the lamellar stacks, an abrupt increase similar to the critical divergence was observed (from 25 nm to 50 nm) in the heating process. Not only for the melting behavior but also in the course of recrystallization, change in the lamellar-thickness distribution was uncovered, which shows strong hysteresis depending on what temperature the sample was cooled down from.