Characterization of biaxial strain of poly(l‐lactide) tubes

Poly(l ‐lactide) in its l ‐form has promising mechanical properties. Being a semicrystalline polymer, it can be subjected to strain‐induced crystallization at temperatures above T_g and can thereby become oriented. Following a simultaneous (SIM) biaxial strain process or a sequential (SEQ) biaxial strain process, the mechanical properties of biaxially strained tubes can be further improved. This study investigated these properties in relation to their morphology and crystal orientation. Both processes yield the same mechanical strength and modulus, yet exhibit different crystal orientation. Through further wide angle X‐ray scattering analysis it was found that the SEQ biaxial strain yields larger interplanar spacing and distorted crystals and looser packing of chains. However, this does not influence the mechanical properties negatively. A loss of orientation in SEQ biaxially strained samples at high degrees of strain was detected, but was not seen for SIM biaxial strain and did not correlate with mechanical performance in either case. However, post‐annealing reduced the orientation to the same level in both cases, and the modulus and strength decreased for both SIM and SEQ biaxial strain. It is therefore concluded that mechanical properties after biaxial strain are related to strain‐induced amorphous orientation and the packing of crystals, rather than strain‐induced crystallinity. © 2015 Society of Chemical Industry