首页 | 本学科首页   官方微博 | 高级检索  
     

磨削用量对40Cr钢磨削淬硬层的影响
引用本文:刘菊东,王贵成,陈康敏. 磨削用量对40Cr钢磨削淬硬层的影响[J]. 中国机械工程, 2006, 17(17): 1842-1845
作者姓名:刘菊东  王贵成  陈康敏
作者单位:1. 集美大学,厦门,361021
2. 江苏大学,镇江,212013
基金项目:国家自然科学基金;福建省教育厅科研项目;福建省厦门市科技型中小企业技术创新基金
摘    要:以平面磨削淬硬试验为基础,研究了磨削用量对40Cr钢磨削淬硬层组织与性能的影响。结果表明,在磨削淬硬加工中的热、力耦合作用下,磨削用量对磨削淬硬层的马氏体组织形貌及其高硬度区硬度值无显著影响,其高硬度值均在HV630~HV680之间。随着磨削速度的提高、磨削深度的增加或工件进给速度的降低,磨削淬硬层表面残余压应力值相应减小,但淬硬层深度以及应力作用深度相应增加。

关 键 词:磨削  表面淬硬  显微组织  显微硬度  淬硬层深度  残余应力
文章编号:1004-132X(2006)17-1842-04
收稿时间:2005-09-28
修稿时间:2005-09-28

Effect of Grinding Parameters on the Grinding-Hardened Layer of 40Cr Steel
Liu Judong,Wang Guicheng,Chen Kangmin. Effect of Grinding Parameters on the Grinding-Hardened Layer of 40Cr Steel[J]. China Mechanical Engineering, 2006, 17(17): 1842-1845
Authors:Liu Judong  Wang Guicheng  Chen Kangmin
Abstract:On the basis of the surface grinding-hardening test,the influences of the grinding parameters on microstructures and properties of grinding hardened layer of 40Cr steel were studied.The results show that under the coupling actions of the thermal and mechanics during the grinding hardening process,there are no remarkable effects of the grinding parameters upon the martensite configuration and micro-hardness value in high-hardness area of the hardened layer.The high hardness value of the hardened layer is of HV630~HV680.When the wheel speed and depth of cut increase,or feed rate decreases,the compressive residual stresses of the hardened layer surface decrease accordingly,whereas the hardened layer depth and the action depth of residual stresses increase accordingly.
Keywords:grinding  surface hardening  microstructure  micro-hardness  hardened layer depth  residual stress
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号