Moisture Diffusion Coefficients for Modeling the First and Second Drying Sections of Green Bricks

A model has been developed that describes the dependence of the moisture diffusion coefficient on the water fraction. Until the end of shrinkage has been achieved, the moisture diffusion coefficient is proportional to the second power of the water fraction. Due to shrinkage, the relevant capillary spaces available for water transport become smaller. Consequently, the moisture diffusion coefficient decreases continually. After the end of shrinkage, the flow resistance to the water moving toward the surface increases sharply due to penetrating air. This leads to a steep drop of the moisture diffusion coefficient by several powers of ten. Measurements were carried out with specimens of defined geometry to determine the moisture diffusion coefficient. On the basis of a specified limiting value, the model is capable of calculating the moisture diffusion for all initially specified raw materials moistures. The moisture can also be determined if the degree of drying shrinkage is known. Using the determined moisture diffusion coefficient, the first and the second drying section can be located. Drying tests were carried out in a laboratory dryer and the experimental results obtained were compared to the simulation results. The simulation results are in good agreement with the experimental results.