Buckling of elastic—plastic square tubes under bending

This paper addresses the response, buckling and collapse of long, thin-walled, seamless steel square tubes under pure bending using a combined experimental and analytical approach. All tubes tested had nominal cross-sections with height equal to 1 in. (25.4 mm) and ranged in height-to-thickness ratios (h/t) from 15.4 to 28.6. The experiments were conducted under curvature control. It was found that the deformation of the cross-section that accompanied bending was uniform along the tubes for low values of curvature. At higher values, periodic ripples with wavelengths approximately equal to the width of the cross-section appeared on the compression flange. These ripples increased in amplitude with further bending. For tubes with higher h∼ the increase was more pronounced. Tubes with lower h/t showed more moderate increases in ripple amplitude but developed regions spanning several ripples in which the cross-section deformation was more pronounced. In all cases, collapse occurred when a kink formed on the compression flange of the tube.Rayleigh—Ritz type formulations based on the principle of virtual work were developed to predict the response and buckling of the tubes. Results include predictions of the response considering the effect of uniform cross-section deformation and predictions of the critical curvature at which the ripples appear. The numerical results are in good agreement with experimental observations.