Thermal shock behavior of nanostructured and conventional Al2O3/13 wt%TiO2 coatings fabricated by plasma spraying

The thermal shock behavior of three kinds of Al₂O₃/13 wt%TiO₂ coatings fabricated by plasma spraying was studied in this paper. One kind of those coatings was derived from conventional fused and crushed feedstock powder available commercially; the other two kinds of coatings were derived from nanostructured agglomerated feedstock powders. These two nano coatings possess moderate pores and pre-existing microcracks, they were composed of fused structure and three-dimensional net or skeleton-like structure. For conventional coatings, the pores and pre-existing cracks were bigger, sharp-point and mostly distributed between splats. Thermal shock tests for the three coatings were performed by water quenching method. Testing result showed the two kinds of nano coatings had much higher thermal shock resistance than the conventional coatings. The improved thermal shock resistance for nano coatings could attribute to their improved microstructure and crack propagation mode. The damage evolution and failure mechanism of coatings was quite different at thermal shock temperature of 650 °C and 850 °C, which was explained by a simple model. Different crack propagating modes in nanostructured and conventional coatings during thermal shock tests were due to their different microstructures in these two kinds coatings. The stress state of coating surfaces during the thermal cycles was also discussed in this paper.