| 锥形件单道次拉深旋压成形的数值模拟及试验研究 |
| |
| 引用本文： | 夏琴香,张帅斌,吴小瑜,程秀全. 锥形件单道次拉深旋压成形的数值模拟及试验研究[J]. 锻压技术, 2010, 35(1). DOI: 10.3969/j.issn.1000-3940.2010.01.012 |
| |
| 作者姓名： | 夏琴香 张帅斌 吴小瑜 程秀全 |
| |
| 作者单位： | 华南理工大学机械与汽车工程学院,广东,广州,510640;广州民航职业技术学院机务工程系,广东,广州,510403 |
| |
| 基金项目： | 国家自然科学基金资助项目(50775076) |
| |
| 摘 要： | 采用有限元分析软件MSC.MARC对锥形件单道次拉深旋压过程进行数值模拟,并且对其应力应变分布规律进行了研究,重点研究了旋轮进给比以及毛坯厚径比对板材成形质量的影响,分析了起皱、减薄、回弹现象产生的原因以及容易出现这些缺陷的部位。模拟及试验结果表明,与锥形件普通拉深成形相类似,口部(即成形过程中的坯料凸缘)和侧壁中下部靠近圆角处是锥形件单道次拉深旋压过程中易分别产生起皱和破裂的部位,应特别予以关注。
|
| 关 键 词： | 锥形件 拉深旋压 应力应变 数值模拟 |
Numerical simulation and experimental investigation on one-path deep drawing spinning of conical part |
| |
| XIA Qin-xiang,ZHANG Shuai-bin,WU Xiao-yu,CHENG Xiu-quan. Numerical simulation and experimental investigation on one-path deep drawing spinning of conical part[J]. Forging & Stamping Technology, 2010, 35(1). DOI: 10.3969/j.issn.1000-3940.2010.01.012 |
| |
| Authors: | XIA Qin-xiang ZHANG Shuai-bin WU Xiao-yu CHENG Xiu-quan |
| |
| Affiliation: | 1.School of Mechanical and Automotive Engineering;South China University of Technology;Guangzhou 510640;China;2.Department of Airplane Maintenance Engineering;Guangzhou Civil Aviation College;Guangzhou 510403;China |
| |
| Abstract: | The process of one-path deep drawing spinning for the conical part was simulated by the finite element software,MSC.MARC,and the stress-strain distribution was studied.The influences of feed rate of the roller and the ratio of thickness to diameter of the blank on the forming quality were mainly investigated.The causes of the forming defects,such as wrinkling,thinning and springback,and the defect position were analyzed.Both the simulation and experiment results show that wrinkling and thinning occur easily... |
| |
| Keywords: | conical part drawing-spinning stress strain numerical simulation |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
