| 基于dsPIC30F4013和CAN总线的传感器节点设计 |
| |
| 引用本文： | 孟鹏花,司宝锋.基于dsPIC30F4013和CAN总线的传感器节点设计[J].机械工程与自动化,2010(1):97-99. |
| |
| 作者姓名： | 孟鹏花 司宝锋 |
| |
| 作者单位： | 中北大学,光电仪器厂,山西,太原,030051 |
| |
| 摘 要： | 结合实际需要,提出一种基于CAN总线的传感器节点设计方法。系统MCU采用集成了CAN控制器的dsPIC30F4013。通过12位A/D转换器采集到各种传感器的信号,经由MCU预处理后,再通过CAN总线传输给上位机。该方案在很大程度上减轻了上位机的负担,同时也提高了系统的健壮性。
|
| 关 键 词： | 传感器 CAN dsPIC30F4013 设计 |
Sensor Node Design Based on dsPIC30F4013 and CAN Bus |
| |
| MENG Peng-hua,SI Bao-feng.Sensor Node Design Based on dsPIC30F4013 and CAN Bus[J].Mechanical Engineering & Automation,2010(1):97-99. |
| |
| Authors: | MENG Peng-hua SI Bao-feng |
| |
| Affiliation: | MENG Peng-hua,SI Bao-feng(Xinyuan High-tech Center of North University of China,Taiyuan 030051,China) |
| |
| Abstract: | In light of the requirement to the multi-sensor system,this paper brought up a sensor node design method based on CAN bus.In the system,dsPIC30F4013 integrating CAN controller was used as MCU,the signals from various sensors were converted by a 12 bit A/D converter,and then the data were pretreated by MCU,and transmitted to the host computer through CAN bus.The program could reduce the burden of the host computer,and improve the system robustness. |
| |
| Keywords: | CAN dsPIC30F4013 |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
