旋钮挡圏落料拉伸冲孔复合模设计 |
| |
引用本文: | 陈永挺,张懃. 旋钮挡圏落料拉伸冲孔复合模设计[J]. 模具制造, 2013, 13(3): 9-11 |
| |
作者姓名: | 陈永挺 张懃 |
| |
作者单位: | 浙江黄岩冲模厂 浙江黄岩318020 |
| |
摘 要: | 对于凸缘筒型件的落料、拉伸和冲孔三序加工,通常采用分序或级进模工艺方法,本文采用复合模一副模具完成三序工作内容,收到了很好的效果,同时还介绍了三序复合模设计的注意事项。
|
关 键 词: | 落料 拉伸 冲孔 复合模 |
Design of Blanking-Drawing-Piercing Compound Die for the Knob Retaining Ring |
| |
Abstract: | It usually adopts points sequence or progressive die process method to flange cartridge type parts blanking drawing and piercing three-order processing. This article uses one set of compound die to complete three-sequence work content, receiving good effect. This article also introduces the matters needing attention of three-sequence. |
| |
Keywords: | blanking drawing piercing compound die |
本文献已被 CNKI 维普 万方数据 等数据库收录! |
|