High-temperature thermal barrier coating formation by laser alloying of CP-Ti with pre-placed Ni-SiC coating

High-temperature thermal barrier coating was created on CP-Ti using a pre-placed Ni-SiC layer by laser alloying technique. The coating was developed using 80% Ni + 20% SiC, 50% Ni + 50% SiC and 60% Ni + 40% SiC, and the latter two compositions are found to be efficient in producing a uniform layer. The 100% SiC pre-placement was also used. A flaw-less coating of 0.4–0.6 mm thickness was produced at a lower power density of 1.3 to 1.9 × 10⁵ W cm^–2. Very high power density of 2.5–3.0 × 10⁵ W cm^–2 is inefficient to produce uniform coating. The laser alloyed coating consists of dendrites and intermetallic precipitates. The degree of dendrite population depends upon the coating composition and laser processing conditions. The coating hardness was 600–1200 HV, which is three to six times higher than the base titanium. Uniform hardness was obtained for the coatings produced at a laser power density of 1.3 × 10⁵ W cm^–2. The titanium silicide (TiNiSi, Ti₅Si₃, TiSi) and nickelide (NiTi₂) phases formed on the laser-alloyed coating surface was confirmed by X-ray analysis. These intermetallic phases can improve high-temperature properties of titanium and its alloys. The effect of laser power density and coating composition on the alloying depth alloying width, hardness and microstructure are discussed. The present work investigated the microstructure evolution, hardness and compound phases by means of optical and scanning electron microscopy, Vickers hardness testing, EDXRD and SIMS analysis. A 5 kW CW CO₂ laser was used for laser alloying experiments.