MECHANICALLY SHORT CRACK GROWTH FROM NOTCHES IN A MILD STEEL

Abstract— Two L-notched specimens made of mild steel (average grain size =30 μm) and having root radii of 0.1 mm and 3 mm, and also a smooth surface specimen were cyclically loaded at different stress levels at R =?1 and at R = 0. A technique based on miniature strain gauges was successfully used to monitor the depth and the opening level of mechanically short cracks of depths from 0.015 mm to 0.5 mm. Three dimensional FEM computations were made to obtain appropriate calibration curves for varying crack aspect ratios and gauge eccentricities as well as notch plastic strain distributions. The fracture of L-notched specimens having a root radius of 0.1 mm was characterized by an early and multiple crack initiation phase (defined by a crack depth of 30 μm), and the short crack growth rates showed a mechanical behaviour different from that of long cracks (large discrepancies at the same Δ K -value, crack deceleration at R =?1 even beyond the notch plastic zone). For smooth surface specimens both the initiation and the propagation of a single short crack represented important fractions of the total life; the short crack growth rates were high and continuously increasing. The notch influence was highly reduced when the stress singularity is truncated by a 3 mm radius. The cracking behaviour was, in several aspects, close to that at smooth surfaces. The evolutions of crack closure were analyzed in each condition (transient decrease and stabilized value of the closure ratio U =Δ K _eff/Δ K ) and were shown to have a strong influence on short crack growth. Most of the short crack growth rates obtained in the various geometry/loading conditions are well consolidated with LEFM long crack growth rates using the Δ K _eff parameter.