From microstructure to the development of water and major reaction sites inside the catalyst layer of the cathode of a proton exchange membrane fuel cell

Microstructures of various sizes and shapes are fabricated on the surface of the catalyst layer (CL) of the cathode of a PEMFC, adjacent to the micro porous layer (MPL). Three major experimental results are: (1) performance is improved by up to 60% and the percentage of the increase is the same as that of the increase in interface area of CL and MPL; (2) the cell suffers no significant performance loss when Pt loading of the cathode is reduced from 1 to 0.25 mg cm⁻² and; (3) transient responses in periodical linear sweep tests show an obvious performance “jump” for all the cathodes with microstructures when approaching steady state, but none for others. Based on observations, a proposal related to the development of water and, consequently, the major reaction sites in the CL is made: there is a general water “surface” inside the CL. Major electrochemical reactions occur above (on the MPL side) of this surface and within a limited height. The surface will “move” from the membrane toward the MPL as more water is produced. The vapor generation rate (current load) relative to the removal rate of the rest of the cell components will determine the steady state position of this water surface.