| 机床控制系统数控化改造的研究与应用 |
| |
| 引用本文： | 周慧玲,于宁,杨军,贾岭. 机床控制系统数控化改造的研究与应用[J]. 机电工程, 2005, 22(9): 14-17 |
| |
| 作者姓名： | 周慧玲 于宁 杨军 贾岭 |
| |
| 作者单位： | 北京邮电大学,自动化学院,北京,100876 |
| |
| 摘 要： | 给出了基于SiemensSinumerik 802D数控系统改造德国BFT130/5型镗铣床的方案;对用PLC取代部分原电气控制的过程做了具体分析,并提出了一些经验性的总结;分析阐述了在数控系统调试过程中对关键参数应如何设置.
|
| 关 键 词： | PLC 数控系统 |
| 文章编号： | 1001-4551(2005)09-0014-04 |
| 收稿时间： | 2005-05-15 |
| 修稿时间： | 2005-06-23 |
The Research and Application in Updating Control System of Machine Tool with Numerical Control System |
| |
| ZHOU Hui-Ling,YU Ning,YANG Jun,JIA Ling. The Research and Application in Updating Control System of Machine Tool with Numerical Control System[J]. Mechanical & Electrical Engineering Magazine, 2005, 22(9): 14-17 |
| |
| Authors: | ZHOU Hui-Ling YU Ning YANG Jun JIA Ling |
| |
| Affiliation: | The Automation School, Beijing University of Posts and Telecommunication, Beifing 100876, China |
| |
| Abstract: | Based on SiemensSinumerik 802D numerical control system(NCS),this paper proposes the method of updating the control system of Germanic BFT130/5 boring and milling machine.The process that the PLC replaces parts of the electrical control is analyzed in detail.Some experiential conclusions and how to set the key parameters of the NCS are also presented in this paper. |
| |
| Keywords: | PLC numerical control system |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
