| 注塑机拉杆与模板的有限元分析 |
| |
| 引用本文： | 周雄新,欧笛声.注塑机拉杆与模板的有限元分析[J].广西工学院学报,2007,18(4):60-62,76. |
| |
| 作者姓名： | 周雄新 欧笛声 |
| |
| 作者单位： | 1. 广西大学,机械工程学院,广西,南宁,530004
2. 广西工学院,机械工程系,广西,柳州,545006 |
| |
| 基金项目： | 广西壮族自治区科技厅青年基金项目(桂科青0728013) |
| |
| 摘 要： | 注塑机拉杆和模板是重要的承载零件,易因设计不良而发生早期断裂或出现裂纹的现象。本文采用整体有限元分析方法对肘杆式注塑机的拉杆和模板进行应力分析,并就分析结果对注塑机拉杆与模板的设计提出了改进措施。
|
| 关 键 词： | 注塑机 拉杆 模板 有限元分析 |
| 文章编号： | 1004-6410（2007）04-0060-03 |
| 收稿时间： | 2007-10-11 |
| 修稿时间： | 2007年10月11 |
Finite element analysis of tie-bars and platens of a plastic injection machine |
| |
| ZHOU Xiong-xin,OU Disheng.Finite element analysis of tie-bars and platens of a plastic injection machine[J].Journal of Guangxi University of Technology,2007,18(4):60-62,76. |
| |
| Authors: | ZHOU Xiong-xin OU Disheng |
| |
| Abstract: | The tie-bars and platens of a plastic injection machine are important parts of carrying load.Premature failure and crack often occur to them if they were not designed elaborately.This paper utilized the finite element analysis method of an integrated model to analyze the stresses of tie-bars and platens of a plastic injection machine with toggle clamping unit.,and provide credible warrant for improving the design of tie-bars and platens of a plastic injection according to the result of analysis. |
| |
| Keywords: | plastic injection machine tie-bar platens finite element analysis |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
