Microstructure evolution and mechanical properties of GH984G alloy with different Ti/Al ratios during long-term thermal exposure

GH984G alloy is a low cost Ni–Fe based wrought superalloy designed for 700 °C advanced ultra-supercritical (A-USC) coal-fired power plants. In this paper, the microstructure evolution and tensile properties of GH984G alloy with different Ti/Al ratios during thermal exposure at different high temperatures are investigated. Detailed microstructure analysis reveals that the Microstructure of alloys with different Ti/Al ratios are similar after standard heat treatment, and the primary precipitates are γ′, MC, M₂₃C₆ and M₂B. However, η phase precipitates at grain boundary in the alloy with high Ti/Al ratio after thermal exposure at 750 °C for 570 h. By contrast, the microstructure stability of the alloy with lower Ti/Al ratio is excellent. There is no detrimental phase even if after thermal exposure at 750 °C for 5000 h in the alloy with lower Ti/Al ratio. γ′ coarsening plays a great role on the tensile strength, and the critical size range of γ′ could be defined as approximately 27–40 nm. The influence of η phase on tensile strength has close relationship with its volume fraction, the high volume fraction results in the decrease of tensile strength. The tensile strength of the alloy with lower Ti/Al ratio is obviously higher than the alloy with higher Ti/Al ratio and the yield strength has no obvious decrease during long-term thermal exposure at 700 °C. It is demonstrated that the thermal stability of microstructure and mechanical properties of GH984G alloy can be improved by moderately decreasing Ti/Al ratio to satisfy the requirement of A-USC plants.