| 小管冲孔模设计 |
| |
| 引用本文： | 郭德喜. 小管冲孔模设计[J]. 模具工业, 2000, 0(7): 13-14 |
| |
| 作者姓名： | 郭德喜 |
| |
| 作者单位： | 卫东机械厂,湖北,襄樊,441021 |
| |
| 摘 要： | 介绍了在6.4mm管材上冲2mm小孔的工艺、模具结构及冲孔模工作过程 ,使用该冲孔模提高了生产效率 ,满足了产品的质量要求
|
| 关 键 词： | 冲孔模 凸模 凹模 |
| 修稿时间： | 1999-12-22 |
Design of the Piercing Die for Small Tubes |
| |
| Guo Dexi. Design of the Piercing Die for Small Tubes[J]. Die & Mould Industry, 2000, 0(7): 13-14 |
| |
| Authors: | Guo Dexi |
| |
| Abstract: | An introduction was made on the technological process of piercing small holes of 2mm in the wall of the 6.4mm tube, on the die structure and on the working process of the piercing die. The design enhanced the productivity and met the quality requirement of the products. |
| |
| Keywords: | piercing die punch matrix |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
