| 浅析《极限配合与测量技术基础》之形位公差带 |
| |
| 引用本文： | 张昌娟,高保彬,刘传绍.浅析《极限配合与测量技术基础》之形位公差带[J].机械管理开发,2012(3):20-21,23. |
| |
| 作者姓名： | 张昌娟 高保彬 刘传绍 |
| |
| 作者单位： | 1. 河南理工大学机械与动力工程学院
2. 河南理工大学安全科学与工程学院,河南焦作454000 |
| |
| 摘 要： | 为了满足零件的使用要求,保证零件的互换性和制造经济性,在设计时应对零件的形位误差给以必要而合理的限制,规定零件的形状和位置公差。结合教学经验,总结一定的规律和共性,提出了积木法和剖视法来分析形位公差带和形位公差项目之间的关系,取得了良好的教学效果。
|
| 关 键 词： | 形位公差带 积木法 剖视法 |
Analysis on Geometrical Tolerance Zone of Limits & Fits and Technology Measurement Foundation |
| |
| ZHANG Chang-juan,GAO Bao-bin,LIU Chuan-shao.Analysis on Geometrical Tolerance Zone of Limits & Fits and Technology Measurement Foundation[J].Mechanical Management and Development,2012(3):20-21,23. |
| |
| Authors: | ZHANG Chang-juan GAO Bao-bin LIU Chuan-shao |
| |
| Affiliation: | 1(1School of Mechanical and Power Engineering, Henan Polytechnic University; 2. School of Safety Science and Engineering, Henan Polytechnic University, Jiaozuo 454000, China) |
| |
| Abstract: | In order to meet the operating requirements of parts and ensure the interchangeability and manufacture cost, the form & position error should be limited reasonably and the form & position tolerance must be provided in the design process. In the paper, combining my teaching experience and summarizing certain rule and commonality, building blocks and section are put forward to analyze geometrical tolerance zone and their relations, therefore good teaching effects are acquired. |
| |
| Keywords: | geometrical tolerance zone building blocks section |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
