Investigation of mechanical properties and fatigue life of ECARed AA5083 aluminium alloy

Equal‐channel angular rolling (ECAR) is a continuous severe plastic deformation process. In this process, severe shear strains apply to the sheet. This strain increases the yield or ultimate strength of sheet without significant change in sheet dimension. In this paper, the effect of ECAR process on mechanical properties and fatigue life of manufactured sheets will be studied. Four AA5083 samples have been prepared and annealed for obtaining stress‐free samples. Three samples have been rolled by the ECAR process with one, two and three passes of rolling, respectively. Mechanical tests including tensile test, hardness and axial fatigue tests have been carried out on prepared samples. Fatigue tests have been implemented according to a strain‐based approach with a constant strain ratio equal to 0.75 and 0.5 Hz frequency of loading. All of the tests have been carried out in controlled laboratory conditions. Results show that the ultimate tensile strength of samples increases with increasing the pass of rolling. Also, the maximum elongation of samples decreases. Maximum elongation was 17% in annealed samples, while it decreases to 10% in samples with three passes of rolling. The hardness of samples has been measured, and the results show an increase in hardness for a higher pass of the ECAR process. Fatigue test results show that fatigue life of AA5083 samples decreases in manufactured sheets of the ECAR process. Also, cyclic softening has been observed in the ECARed sample. The fracture surfaces of samples after fatigue test have been observed with a scanning electron microscope. A comparison of fracture surfaces confirms that the crack growth was intergranular in annealed samples while it changes in ECARed samples to transgranular.