| TIG焊修理钢模的工艺参数的研究 |
| |
| 引用本文： | 金美华. TIG焊修理钢模的工艺参数的研究[J]. 模具技术, 2007, 0(4): 60-62 |
| |
| 作者姓名： | 金美华 |
| |
| 作者单位： | 南京工业职业技术学院,机械工程系,江苏,南京,210046 |
| |
| 摘 要： | 分析中碳钢、铬钼合金钢、析出硬化钢模具用TIG焊修理时工艺流程的条件参数、预热温度、热处理温度、焊接后硬度及注意事项.通过借鉴国外的生产加工工艺参数,详细介绍了淬火和回火处理的碳钢和低合金钢特种模具修理时,应用钨极惰性气体保护氩弧焊的工艺参数及注意事项.将多次实验得出的结论,应用到我国的生产线上,降低生产成本,促进制造业的发展.
|
| 关 键 词： | TIG焊 模具 工艺参数 注意事项 |
| 文章编号： | 1001-4934（2007）04-0060-03 |
| 收稿时间： | 2007-03-20 |
| 修稿时间： | 2007-03-20 |
Study on the parameter of TIG welding for die repairing |
| |
| JIN Mei-hua. Study on the parameter of TIG welding for die repairing[J]. Die and Mould Technology, 2007, 0(4): 60-62 |
| |
| Authors: | JIN Mei-hua |
| |
| Affiliation: | JIN Mei-hua |
| |
| Abstract: | Main process parameter of Tungsten Inert Gas arc welding (TIG),preheat temperature,heat treatment temperature,welded hardness and notes for die repair of S55C,SCM430,3Ni-Al-1Cu was analyzed.By learning from the overseas process parameter,cautions for TIG welding for hardening and temper processing carbon steel and the special low-alloy die.Conclusions obtained from several experiment were applied on the production line to reduce manufacturing cost and promote manufacturing development. |
| |
| Keywords: | TIGwelding die process parameter caution |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
