Weakened anisotropy of mechanical properties in rolled ZK60 magnesium alloy sheets with elevated deformation temperature

The rolling direction (RD) and the transverse direction (TD) samples were obtained from an as-rolled ZK60 magnesium alloy sheet with strong anisotropy of initial texture and their mechanical properties were tested at various deformation temperatures. Meanwhile, the microstructure and texture of these samples after fracture were investigated. Results revealed that a higher flow stress along the RD than that along the TD at room temperature were ascribed to the strong anisotropy of transitional texture, and this texture effect was remarkably weakened with the increase of deformation temperature. Deformation structure was dominant at 100 °C, and was replaced by dynamic recrystallization structure when the deformation temperature increased to 200 °C and 300 °C. The texture presented a strong texture (transitional texture in the RD sample and basal texture in the TD sample) at 100 °C, but its intensity visibly decreased and texture components became more disperse at 200 °C and 300 °C. These microstructure and texture results were employed in conjunction with calculated results to argue that raising deformation temperature could increase the activity of non-basal slip by tailoring the relative critical resolved shear stress of each deformation mode and finally result in low texture effect on mechanical anisotropy.