| 轴承预紧对机床主轴刚度的影响 |
| |
| 引用本文： | 罗平,穆杨,刘恒,景敏卿.轴承预紧对机床主轴刚度的影响[J].机床与液压,2011(17). |
| |
| 作者姓名： | 罗平 穆杨 刘恒 景敏卿 |
| |
| 作者单位： | 西安交通大学机械电子及信息系统研究所; |
| |
| 基金项目： | 机床重大专项(2009ZX04001-071); 国家自然基金面上项目(51075315); 国家973项目(2007CB707705) |
| |
| 摘 要： | 阐明了用有限元法分析计算机床主轴组件刚度的步骤和方法,并对主轴刚度进行计算,讨论不同预紧条件下,轴承刚度对主轴性能的影响;并探讨轴承预紧后,增大预紧量对主轴刚度的影响。结果表明:支承轴承预紧的增大使主轴弯曲刚度增幅最大为22%,而对固有频率的影响不明显。
|
| 关 键 词： | 机床主轴 主轴刚度 预紧 |
Effect of Bearing Preload on Machine Tool Spindle Rigidity |
| |
| LUO Ping,MU Yang,LIU Heng,JING Minqing.Effect of Bearing Preload on Machine Tool Spindle Rigidity[J].Machine Tool & Hydraulics,2011(17). |
| |
| Authors: | LUO Ping MU Yang LIU Heng JING Minqing |
| |
| Affiliation: | LUO Ping,MU Yang,LIU Heng,JING Minqing(Institute of Mechatronics and Information Systems,Xi'an Jiaotong University,Xi'an Shaanxi 710049,China) |
| |
| Abstract: | Finite element analysis procedure and calculation method of rigidity on spindle unit of the machine tool were expounded,and calculation of the spindle rigidity was made.The effects of bearing stiffness to spindle performance under the conditions of different preload were discussed.The effect of increasing preload on spindle rigidity was discussed.The results show that the spindle bending rigidity is increased by 22% at maximum,while the effect to the natural frequency is not obvious,during the increasing of... |
| |
| Keywords: | Machine tool spindle Spindle rigidity Preload |
| 本文献已被 CNKI 等数据库收录！ |
|
