| 基于UG的专用后处理器的配置 |
| |
| 引用本文： | 姜海林,刘海涛,程学进. 基于UG的专用后处理器的配置[J]. 机床与液压, 2011, 0(18): 34-36 |
| |
| 作者姓名： | 姜海林 刘海涛 程学进 |
| |
| 作者单位： | 淮阴工学院机械工程学院; |
| |
| 摘 要： | 针对默认后处理器不方便使用的现状,根据实际需要利用UG配置了Fanuc Oi Mate专用后处理器.经该专用后处理器生成的NC代码不需要作任何修改,就可直接输入到数控机床中使用,使操作人员免除了手动修改NC代码的繁琐工作.
|
| 关 键 词： | NC代码 后处理器 UG软件 |
Configuration of Special Postprocessor Based on UG |
| |
| JIANG Hailin,LIU Haitao,CHENG Xuejin. Configuration of Special Postprocessor Based on UG[J]. Machine Tool & Hydraulics, 2011, 0(18): 34-36 |
| |
| Authors: | JIANG Hailin LIU Haitao CHENG Xuejin |
| |
| Affiliation: | JIANG Hailin,LIU Haitao,CHENG Xuejin(Faculty of Mechanical Engineering,Huaiyin Institute of Technology,Huaian Jiangsu 223003,China) |
| |
| Abstract: | The default postprocessor is not convenient.To solve this problem,a special Fanuc 0i Mate postprocessor was configurated by UG according to actual demand.The NC code generated by the special postprocessor can be directly transmitted to NC machine without any modification. |
| |
| Keywords: | NC code Postprocessor UG software |
| 本文献已被 CNKI 等数据库收录！ |
|
