| V形件弯曲凹模最小深度的确定 |
| |
| 引用本文： | 彭炎荣,罗文波,李名望,江荧,彭定.V形件弯曲凹模最小深度的确定[J].模具技术,2004(4):33-35,58. |
| |
| 作者姓名： | 彭炎荣 罗文波 李名望 江荧 彭定 |
| |
| 作者单位： | 1. 湖南铁道职业技术学院,机电工程系,湖南,株州,412001
2. 湘潭大学,基础力学与材料工程研究所,湖南,湘潭,411105 |
| |
| 摘 要： | 该文指出了目前广泛使用的经验查表法确定V形件弯曲凹模深度的不合理性，分析了凹模斜壁的作用及其与圆角半径的相互关系，提出了凹模最小的深度的概念和计算公式。
|
| 关 键 词： | V形弯曲 凹模深度 变形区 |
| 文章编号： | 1001-4934(2004)04-0033-03 |
Determination of Minimum Depth of Bending Female Die for V-shaped Parts |
| |
| PENG Yan rong,LUO Wen bo,LI Ming wang et al..Determination of Minimum Depth of Bending Female Die for V-shaped Parts[J].Die and Mould Technology,2004(4):33-35,58. |
| |
| Authors: | PENG Yan rong LUO Wen bo LI Ming wang |
| |
| Abstract: | This paper pointed out the invalidity of determination of bending female die depth of V shaped parts by means of experiential tables, which is used extensively at present. The action of the incline face of female die and its relation with corner radius were analyzed. The concept of minimum depth of female die and its calculated formula were put forward. |
| |
| Keywords: | V shaped bending die depth deformed zone |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
