| 锅盖落料拉伸冲孔切边复合模设计 |
| |
| 引用本文： | 杨宝顺.锅盖落料拉伸冲孔切边复合模设计[J].模具制造,2006(1):31-34. |
| |
| 作者姓名： | 杨宝顺 |
| |
| 作者单位： | 福州大学机械工程学院,福建,福州,350002 |
| |
| 摘 要： | 分析了不锈钢锅盖成形工艺，确定了用一副复合模完成落料、浅球形的正向拉伸和低锥形的反向拉伸、冲孔和切边的工序过程。同时也阐述了复合模工作过程及注意事项。
|
| 关 键 词： | 锅盖 工艺 复合模 浅球形 低锥形 拉伸 |
Compound Die Design of Blanking-Drawing Piercing-Trimming for the Pot-Lid |
| |
| Yang Baoshun.Compound Die Design of Blanking-Drawing Piercing-Trimming for the Pot-Lid[J].Die & Mould Manufacture,2006(1):31-34. |
| |
| Authors: | Yang Baoshun |
| |
| Abstract: | The forming process of stainless steel pot-lid die is analyzed, and the procedures are determined to use one pair of compound die to perform blanking material, positive drawing of shallow globe-shaped and negative drawing of low taper, piercing and trimming. In addition, both the working process of compound die and questions required attention are stated. |
| |
| Keywords: | pot-lid process compound die shallow globe-shaped low taper drawing |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
