A geo-engineering classification for rocks and rock masses

In this article, an attempt is made to assess the reliability of predicting the uniaxial compressive strength and the corresponding modulus of a rock mass by current approaches. These two basic engineering properties, when estimated from rock mass rating (RMR), Q and geological strength index (GSI), indicate hardly any change in the modulus ratio with the change in the quality of the rock mass from very good to very poor. However, the modulus ratio obtained from the relations involving the joint factor, J_f, indicate a definite decrease in the modulus ratio with a decrease in the quality of the rock mass. The strength and modulus in the unconfined and confined states, the modulus ratio and failure strain in the unconfined case were linked to J_f in earlier publications based on a large experimental database. Some of these relations were adopted to verify the response of jointed test specimens, the response of the rock mass during excavations for mining and civil underground chambers, in establishing ground reaction curves including the extent of the broken zone, and the bearing capacity of shallow foundations.The joint factor is now linked to RMR, Q and GSI. The prediction of compressive strength and modulus of the rock mass appears to be more suitable. For classifying the rock, based on these properties, the Deere and Miller engineering classification, applicable to intact rocks, has been suitably modified and adopted. The results of different modes of failure of jointed specimens establish definite trends of changes in the modulus ratio originating from the intact rock value on the modified Deere and Miller plot. A geo-engineering classification is evolved by considering strength, modulus, quantifiable weathering index and lithological aspects of the rock.