| 虚拟环境下数控机床建模与仿真 |
| |
| 引用本文： | 陈贵清,杨晓京,李浙昆,樊瑜瑾,毕世英. 虚拟环境下数控机床建模与仿真[J]. 机电工程, 2004, 21(10): 13-15 |
| |
| 作者姓名： | 陈贵清 杨晓京 李浙昆 樊瑜瑾 毕世英 |
| |
| 作者单位： | 昆明理工大学,机电学院,云南,昆明,650093 |
| |
| 基金项目： | 云南省自然科学基金资助项目(2001E0010Q)。 |
| |
| 摘 要： | 基于虚拟样机原理，在Pro/ENGINEER下建立了机床的三维实体模型，并导入ADAMS12.0中进行动力学仿真。在虚拟环境下可观察机床整个机构的三维动态显示和运动过程.并可在样机试制前对设计中可能出现的问题做出精确的预测和改进，为机床的一次性试制成功提供了可靠的保证。
|
| 关 键 词： | 数控机床 Pro／ENGINEER ADAMS12．0 动力学仿真 虚拟设计 |
| 文章编号： | 1001-4551(2004)10-0013-03 |
| 修稿时间： | 2004-04-08 |
Modeling and Simulation of the NC Machine Under the Virtual Environment |
| |
| CHEN Gui-qing,YANG Xiao-jing,LI Zhe-kun,FAN Yu-jin,BI Shi-ying. Modeling and Simulation of the NC Machine Under the Virtual Environment[J]. Mechanical & Electrical Engineering Magazine, 2004, 21(10): 13-15 |
| |
| Authors: | CHEN Gui-qing YANG Xiao-jing LI Zhe-kun FAN Yu-jin BI Shi-ying |
| |
| Abstract: | Based on the principle of virtual prototype machines, building the machine's three-dimensional solid model at Pro/e, and importing the model into ADAMS12.0 to operate dynamics simulation, A designer can not only observe the three-dimensional dynamic movements of the whole machine in the virtual circumstance, but also forecast accurately and solve possible problems during design before the prototype is manufactured, assuring the feasibility of design scheme, shortening the period of product design and reducing the cost of production. It offers reliable assurance for the NC machine one-off trial-manufacture success. |
| |
| Keywords: | numerical control machine Pro/ENGINEER ADAMS12.0 dynamics simulation virtual design |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
