首页 | 本学科首页   官方微博 | 高级检索  
     

齿距误差对弧齿锥齿轮齿间载荷分配和强度的影响
引用本文:周彦伟,邓效忠,方宗德,魏冰阳.齿距误差对弧齿锥齿轮齿间载荷分配和强度的影响[J].中国机械工程,2002,13(17):1518-1520.
作者姓名:周彦伟  邓效忠  方宗德  魏冰阳
作者单位:[1]浙江大学流体传动及控制国家重点实验室,杭州市310027 [2]浙江大学机械能源学院机械工程系电子控制工程研究所
基金项目:国家自然科学基金资助项目 (5 0 175 0 90 )
摘    要:采用齿轮啮合仿真和承载啮合仿真技术,研究了重合度达到2.0的弧齿锥齿轮的齿距误差对啮合性能的影响,针对航空弧齿锥齿轮允许的齿距误差,研究了误差量值对齿轮实际重合度,传动误差、齿间载荷分配和弯曲强度的影响。结果表明,相对齿距误差将降低齿轮的实际重合度,使单齿承受的载荷量增加,边缘接触加剧,弯曲强度不过,在容许范围内的齿距误差将不会严重影响重合度达到2.0的齿轮传动的性能。

关 键 词:弧齿锥齿轮  齿距误差  载荷分配  弯曲强度
文章编号:1004-132(2002)17-1518-03

Influence of Pitch Error on Load Share between Teeth and Bending Strength of Spiral Bevel Gears
ZHOU Yanwei.Influence of Pitch Error on Load Share between Teeth and Bending Strength of Spiral Bevel Gears[J].China Mechanical Engineering,2002,13(17):1518-1520.
Authors:ZHOU Yanwei
Abstract:Applying TCA(Tooth Contact Analysis)and LTCA (Loaded Tooth Contact Analysis) techniques, the influence of pitch error on the meshing behavior of aviation spiral bevel gears with contact ratio 2.0 was studied. First, the relative pitch error was defined and its amount was selected according to the accuracy of aviation gears, then the influence of this error on real contact ratio,transmission error,load distribution on tooth surfaces and load share between teeth were analyzed numerically. The conclusions state clearly that rear contact ratio will be reduced, load on single tooth surface will be increased, edge contact will be serious, bending strength will be reduced. But, if the related pitch error is small and permitted by accuracy standard of aviation gears, the meshing behavior of spiral bevel gears with contact ratio 2.0 will be not effected.
Keywords:spiral bevel gear    pitch error    load share between teeth    bending strength
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号