首页 | 本学科首页   官方微博 | 高级检索  
     

车辆变速电控系统ECU和显示器之间CAN总线通信设计
引用本文:周娟,陈慧岩. 车辆变速电控系统ECU和显示器之间CAN总线通信设计[J]. 计算机测量与控制, 2003, 11(4): 309-311
作者姓名:周娟  陈慧岩
作者单位:1. 北京军医学院,医学工程系,北京,100071
2. 北京理工大学,车辆与交通工程学院,北京,100081
摘    要:用CAN总线取代传统的变速电控系统的ECU和显示器之间的硬件连接和数据通信,同时为电控系统的其它可能部分采用CAN总线连接打下基础。通过仿真环境下对ECU和显示器之间的CAN总线通信的调试,及其硬件、软件设计的详细分析,得出了CAN总线技术移植到军用车辆上具有可行性的结论。

关 键 词:军用车辆 变速电控系统 ECU 显示器 CAN总线 数据通信 设计
文章编号:1671-4598(2003)04-0309-03
修稿时间:2002-07-19

Design of CAN Communication System Used in the Electronic Controller Unit and the LED display
ZHOU Juan ,CHEN Hui yan. Design of CAN Communication System Used in the Electronic Controller Unit and the LED display[J]. Computer Measurement & Control, 2003, 11(4): 309-311
Authors:ZHOU Juan   CHEN Hui yan
Affiliation:ZHOU Juan 1,CHEN Hui yan 2
Abstract:The work is to investigate the connection and communication between the electronic controller unirt of auto-transmission control system of the vehicles and the LED displayer,with CAN bus not with the traditional cable.In the emulation mode,the software of the communication between the ECU and the displayer is debugged.And also the hardware and software are introduced fully.The experimentation proves that the application of the CAN bus in the electronic controller unit of auto-transmission control system of the vehicles is feasible.
Keywords:military vehicle  electronically controlled system  CAN bus
本文献已被 CNKI 维普 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号