首页 | 本学科首页   官方微博 | 高级检索  
     

用于二乙醇胺脱氢反应的铜锰系催化剂制备条件的研究
引用本文:刘玉娟,金杏妹. 用于二乙醇胺脱氢反应的铜锰系催化剂制备条件的研究[J]. 工业催化, 2008, 16(10): 165
作者姓名:刘玉娟  金杏妹
作者单位:华东理工大学化学与分子工程学院,上海,200237;华东理工大学化学与分子工程学院,上海,200237
摘    要:研究了铜锰系催化剂并流共沉淀法的制备条件对二乙醇胺催化脱氢反应性能的影响。结果表明,在铜锰原子比为1、溶液浓度0.4 mol·L-1、沉淀pH为12、沉淀温度70 ℃、焙烧温度550 ℃和还原温度210 ℃时,催化剂性能最好。在反应温度150 ℃和压力0.8 MPa,催化剂用量为二乙醇胺质量10%的反应条件下反应 5 h,亚氨基二乙酸盐收率可达93.2%。

关 键 词:催化剂工程  铜锰系催化剂  二乙醇胺  催化脱氢  亚氨基二乙酸盐

Study on preparation conditions of Cu-based Mn catalyst for catalytic dehydrogenation of diethanolamine
LIU Yujuan,JIN Xingmei. Study on preparation conditions of Cu-based Mn catalyst for catalytic dehydrogenation of diethanolamine[J]. Industrial Catalysis, 2008, 16(10): 165
Authors:LIU Yujuan  JIN Xingmei
Affiliation:College of Chemistry and Molecular Engineering, East China University of Science & Technology, Shanghai 200237, China
Abstract:Influence of preparation conditions of coprecipitation method on catalytic properties of Cu based Mn catalyst for catalytic dehydrogenation of diethanolamine were studied.The catalytic performance of the catalyst was best prepared under the optimum preparation conditions as follows: Cu/Mn atomic ratio=1, the concentration of mix solution 0.4 mol·L-1, solution pH=12, precipitation temperature 70 ℃,calcination temperature 550 ℃, and reduction temperature 210 ℃. Iminodiacetic salt yield of 93.2%was obtained under the reaction conditions that reaction temperature was 150 ℃, pressure was 0.8 MPa, Cu based Mn catalyst dosage was 10% of diethanolamine mass and reaction time was 5 h.
Keywords:Cu based Mn catalyst   diethanolamine   catalytic dehydrogenation   iminodiacetic salt  catalyst engineering  
本文献已被 维普 万方数据 等数据库收录!
点击此处可从《工业催化》浏览原始摘要信息
点击此处可从《工业催化》下载全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号