| 纳米等离子处理对提高牙科合金金瓷结合性的研究 |
| |
| 引用本文： | 宋君祥,冉均国,苏葆辉,苟立.纳米等离子处理对提高牙科合金金瓷结合性的研究[J].四川大学学报(工程科学版),2004,36(5):74-77. |
| |
| 作者姓名： | 宋君祥 冉均国 苏葆辉 苟立 |
| |
| 作者单位： | 四川大学,材料科学与工程学院,四川,成都,610065 |
| |
| 摘 要： | 为提高烤瓷材料与牙科合金之间的结合强度，采用Ar^ 离子轰击溅射清洁表面处理和等离子体刻蚀活化处理，并在牙科合金表面沉积纳米Al2O3膜，进行纳米表面处理。结果表明，通过处理的牙科合金与烤瓷的结合强度有所提高，当Al2O3膜厚约为1000nm时，抗折强度达到最大，为47．68MPa．与传统方法相比提高近70％，纳米膜的适宜厚度在700～1200nm之间。
|
| 关 键 词： | 牙科合金 纳米技术 结合强度 |
| 文章编号： | 1009-3087(2004)05-0074-04 |
The Improving of the Bond Strength Between Porcelains and Alloy by the Surface Treatment |
| |
| SONG Jun-xiang,RAN Jun-guo,SHU Bao-hui,GOU Li.The Improving of the Bond Strength Between Porcelains and Alloy by the Surface Treatment[J].Journal of Sichuan University (Engineering Science Edition),2004,36(5):74-77. |
| |
| Authors: | SONG Jun-xiang RAN Jun-guo SHU Bao-hui GOU Li |
| |
| Abstract: | In order to increase the bond strength between porcelains and alloy, Ar ion was used to attack the surface of alloy firstly and then a film of nano-Al_2O_3 was deposited on the surface of alloy. The results showed that after the treatment of the surface of alloy, the bond strength between porcelains and alloy could increase by 70%. When the thickness of nano-Al_2O_3 film is 1000 nm,the largest bond strength can reach to 47.68 MPa and the suitable thickness of nano-Al_2O_3 film is between 700 and 1200 nm. |
| |
| Keywords: | dental ceramic alloy nano-technology adhesive intensity |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
