| H13钢表面镀铬和气体渗氮复合处理的组织及性能 |
| |
| 引用本文： | 李春明,朱伟恒,焦东玲,魏兴钊. H13钢表面镀铬和气体渗氮复合处理的组织及性能[J]. 金属热处理, 2020, 45(5): 5-11. DOI: 10.13251/j.issn.0254-6051.2020.05.002 |
| |
| 作者姓名： | 李春明 朱伟恒 焦东玲 魏兴钊 |
| |
| 作者单位： | 华南理工大学 材料科学与工程学院, 广东 广州 510640 |
| |
| 摘 要： | 对调质后的H13钢进行镀铬+540 ℃气体渗氮处理,获得氮化铬表层,然后将其进行耐磨试验,并与同温度经常规气体渗氮及离子渗氮后的H13钢试样进行组织及耐磨性对比。结果表明:3种工艺处理后试样的主要磨损机制为粘着磨损和磨粒磨损,镀铬/渗氮试样表面摩擦因数最低,为0.44,耐磨性最好,但镀铬+渗氮层与基体的结合力最差。
|
| 关 键 词： | H13钢 渗氮 氮化铬 耐磨性 |
| 收稿时间： | 2020-02-05 |
Microstructure and properties of H13 steel treated by chromium plating and gas nitriding |
| |
| Li Chunming,Zhu Weiheng,Jiao Dongling,Wei Xingzhao. Microstructure and properties of H13 steel treated by chromium plating and gas nitriding[J]. Heat Treatment of Metals, 2020, 45(5): 5-11. DOI: 10.13251/j.issn.0254-6051.2020.05.002 |
| |
| Authors: | Li Chunming Zhu Weiheng Jiao Dongling Wei Xingzhao |
| |
| Affiliation: | School of Materials Science and Engineering, South China University of Technology, Guangzhou Guangdong 510640, China |
| |
| Abstract: | The chromium nitride was obtained on the quenched and tempered H13 steel substrate by using chromium plating and gas nitriding at 540 ℃. Then the abrasion resistance test was performed and the microstructure and wear resistance of H13 steel specimens after conventional gas nitriding and ion nitriding at the same temperature were compared. The results show that the main wear mechanisms of the specimens after three different heat treatment are adhesion wear and abrasive wear. The chromium plated and gas nitrided specimens show the lowest average friction coefficient, 0.44, and the wear resistance is the best, but the adhesion between the Cr-plated+gas nitriding layer and the substrate is the worst. |
| |
| Keywords: | H13 steel nitriding chromium nitride wear resistance |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
| 点击此处可从《金属热处理》浏览原始摘要信息 |
|
点击此处可从《金属热处理》下载免费的PDF全文 |
|
