Winsor I-like (micro)emulsion polymerization of styrene initiated by oil-soluble initiator

Batch emulsion polymerization of styrene initiated by an oil-soluble initiator and stabilized by non-ionic emulsifier (Tween 20) has been investigated. The rate of polymerization vs. conversion curve shows the two non-stationary rate intervals typical for the non-stationary-state polymerization. This behavior is a result of the continuous particle nucleation and the decrease of monomer concentration at the reaction loci with increasing conversion. The initial increase of the polymerization rate is attributed to the increase of particle number and the polymerization proceeding under the monomer-saturated condition—the Winsor I-like (micro)emulsion polymerization. The decrease of the polymerization rate is the result of the depressed transfer of monomer from the monomer reservoir to the reaction loci. Above 50 °C the monomer emulsion separates into two phases: the upper transparent monomer phase and the lower blue colored (microemulsion) phase. The polymerization mixture consists of the microdroplets (act as the reaction loci) and large degradable monomer droplets (act as the reservoir monomer and emulsifier). The continuous release of emulsifier from the monomer phase and the microdroplets induce the continuous particle nucleation up to high conversion. The initial formation of large particles results from the agglomeration of unstable growing particles and monomer droplets. The size of large (highly monomer-swollen) particles decreases with conversion and they merge with the growing particles at ca. 40-50% conversion. The coarse initial emulsion transformed during polymerization to the fine (semitransparent) polymer emulsion as a result of the continuous particle nucleation, the shrinking of highly monomer-swollen polymer particles and the depletion of monomer droplets. The low overall activation energy of polymerization is mainly ascribed to the decreased barrier for entering radicals into the latex particles with increasing temperature.