On selective laser melting of ultra high carbon steel: Effect of scan speed and post heat treatment

Selective laser melting is a laser‐based additive manufacturing process applying layer manufacturing technology and is used to produce dense parts from metallic powders. The application of selective laser melting on carbon steels is still limited due to difficulties arising from carbon content. This experimental investigation aims at gaining an understanding of the application of the process on ultra high carbon steel, which is a special alloy with remarkable structural properties suitable for different industrial applications. The feedstock ultra high carbon steel (2.1% C) powder, 20 μm to 106 μm was prepared by water atomizing technique. This powder was used for the selective laser melting to build specimens 10×10×40 mm in dimensions. To decrease the thermal stresses during layer by layer building, laser scanning was done through 5×5 mm random island patterns while layer thickness was 30 μm. Laser beam diameter, maximum power output, layer thickness and scan speed range were 0.2 mm, 100 W, 30 μm and 50–200 mm/s respectively. The process was done inside high purity nitrogen environment, with less than 0.5% oxygen content. The results illustrate the influence of scan speed from 50 to 200 mm/s on product geometry and dimensions, surface roughness, internal porosity and cracks, microstructure and surface hardness. The effect of post heat treatment by heating and holding for one hour (annealing) at different temperatures of 700°C, 750°C, 950°C is studied. The results indicate that selective laser melting is able to produce near to 95% density of ultra high carbon steel parts with acceptable geometry and surface quality. Porosity cracks, and microstructure formed during the process could be controlled through proper selection of process parameters and post heat treatment. Industrial ultra high carbon steel products can be rapidly fabricated by selective laser melting.