Evaluation of feasibility of pelletized wood co-firing with high ash Indian coals

To reduce anthropogenic CO₂ emissions from power plants, biomass is an immediate alternative fuel which has similar properties as coal. In this regard, the present study discusses about pelletized wood (PW) co-firing with high ash Indian coal by conducting co-milling and co-firing trials in a 1000 kg/hr of pilot scale test facility. Indian coals are typically high ash content and low calorific value fuels, therefore, its interaction with coal during combustion and ash deposition have studied in detail. Based on co-milling trails of PW and coal, it was observed that as PW proportion in coal increases, the quantity of particles of size below 50 μm and as well above 500 μm were increased. From co-firing studies, it was observed that higher volatile content in PW helping in stabilizing flames while co-firing. At lower proportions, up to 10% weight PW co-firing with coal, the flame temperature and heat flux values are very close to base test of 100% coal firing. However, beyond 10% by weight of PW co-firing with coal, the flame temperature and heat flux values were increased significantly from 100% coal tests. This is because of higher calorific value of PW than coal. The CO emission was decreased with increase in PW proportion in coal but at 30% of PW in coal, CO emission was increased suddenly. However, NO and SO₂ concentrations were decreased up to 8% and 16% respectively with increase in PW proportion in coal due to lower fuel nitrogen and sulphur content in PW than coal. Analytical analysis of slagging indices suggest that the slagging potential for PW co-firing with coal is increasing as the PW proportion in coal increases.