Effects of fluctuation of fibre orientation on tensile properties of flax sliver-reinforced green composites

Plant-based natural fibres are often used as a reinforcing material for environmentally friendly green composites. Especially, the form of slivers of natural fibres is anticipated for increasing their stiffness and strength. However, the sliver structure has fluctuations in fibre orientation, which decreases their mechanical properties. This paper describes the effects of such fibre orientation fluctuation on tensile properties of fibre-reinforced fully green composites. The composites were reinforced with slivers of high-strength flax fibres, for which a fabrication method called ‘direct method’ was applied. To quantify the morphology of the fibre orientation, fibre orientation angles were measured on fine segments, which were divided into 1 mm × 1 mm squares on a photograph of the whole composite surface. Although it is well-known that tensile strength of unidirectional composites decreases with increasing fibre orientation angle, the tensile strength obtained here did not show any appreciable relation to the statistical properties of measured fibre orientation angles such as average and standard deviation. The concept of two-dimensional (2D) autocorrelation was used in the present study to express the degree of similarity between fibre orientation angles in two different local areas. Results show that, if high 2D autocorrelation coefficients occupy more area on a composite surface, then this composite possesses more regular fibre orientation and tends to exhibit higher tensile strength. This tendency is stronger in the composites close to on-axis alignment, whereas it became weak in the off-axis composites angled more than 15° because of shear fracture.