| Fe-2Ni金属注射成形工艺研究 |
| |
| 引用本文： | 邱光汉,曾舟山,李益民,林好转,曲选辉,黄伯云. Fe-2Ni金属注射成形工艺研究[J]. 粉末冶金材料科学与工程, 1997, 0(2) |
| |
| 作者姓名： | 邱光汉 曾舟山 李益民 林好转 曲选辉 黄伯云 |
| |
| 作者单位： | 中南工业大学粉末冶金国家重点实验室，中南工业大学粉末冶金国家重点实验室，中南工业大学粉末冶金国家重点实验室，中南工业大学粉末冶金国家重点实验室，中南工业大学粉末冶金国家重点实验室，中南工业大学粉末冶金国家重点实验室 长沙，410083，长沙，410083，长沙，410083，长沙，410083，长沙，410083，长沙，410083 |
| |
| 基金项目： | 国家“八六三”高技术计划重点资助项目 |
| |
| 摘 要： | 采用金属粉末注射成形工艺(MIM)制备Fe-2Ni合金。选择了5种石蜡基粘结剂,结果表明,由多组元聚合物组成的粘结剂注射成形性能好,热脱脂后无缺陷,样品形状保持完整。列举最佳工艺参数及烧结合金的机械性能。
|
| 关 键 词： | 金属注射成形技术(MIM) 粘结剂 热脱脂 |
METAL INJECTION MOULDING(MIM)OF A Fe-2Ni ALLOY |
| |
| Qiu Guanghan,Zeng Zhoushan,Li Yiming,Lin Haozhuan,Qu Xuanhui,Huang Baiyun State Key Laboratory for Powder Metallurgy,Central South University of Technology,Changsha,,China. METAL INJECTION MOULDING(MIM)OF A Fe-2Ni ALLOY[J]. materials science and engineering of powder metallurgy, 1997, 0(2) |
| |
| Authors: | Qiu Guanghan Zeng Zhoushan Li Yiming Lin Haozhuan Qu Xuanhui Huang Baiyun State Key Laboratory for Powder Metallurgy Central South University of Technology Changsha China |
| |
| Affiliation: | Qiu Guanghan,Zeng Zhoushan,Li Yiming,Lin Haozhuan,Qu Xuanhui,Huang Baiyun State Key Laboratory for Powder Metallurgy,Central South University of Technology,Changsha,410083,China |
| |
| Abstract: | By using metal injection moulding technology (MIM) a Fe-2Ni alloy was prepared andfive kinds of wax-based binders were used in the process. The properties of MIM green partswere good and there were no defects after thermal debinding. The optimized parameters andmechanical properties of the sintered alloy were also presented. |
| |
| Keywords: | metal injection moulding (MIM) binder thermal debinding |
| 本文献已被 CNKI 等数据库收录！ |
|
