Tensile properties and fracture toughness of a Ti-45Al-1.6Mn alloy at loading velocities of up to 12 m/s |
| |
Authors: | Z. M. Sun T. Kobayashi H. Fukumasu I. Yamamoto K. Shibue |
| |
Affiliation: | (1) Materials Engineering Division, Tohoku National Industrial Research Institute, 983 Sendai, Japan;(2) Osaka University of Education, 582 Osaka, Japan;(3) Present address: the Department of Production Systems Engineering, Toyohashi University of Technology, 441 Toyohashi, Japan;(4) the Research and Development Center, Sumitomo Light Metal Ind. Ltd., 455 Nagoya, Japan |
| |
Abstract: | A γ-base TiAl alloy with duplex microstructure of lamellar colonies and equiaxed γ grains was prepared with a reactive sintering method. Tensile tests and fracture toughness tests at loading velocities up to 12 m/s (strain rate for tensile tests up to 3.2×102/s) were carried out. The micro-structure of the alloy before and after tensile deformation was carefully examined with a scanning electron microscope (SEM) and a transmission electron microscope (TEM). The fractography of the tensile specimens and fracture toughness specimens was studied. The experimental results demonstrated that the ultimate tensile strength (UTS) and yield strength (YS) increase with increasing strain rate up to 10/s and subsequently level off. The UTS and YS exhibited similar strain rate sensitivity. The strain rate sensitivity exponent at strain rates lower than 10/s is about 1.5×10−2 and at higher strain rates is almost zero. In this study, fracture toughness was found to be less sensitive to the loading velocity, having values of around 25 MPa √m, which is believed to be attributed to the high strain rate experienced at the crack tip. The predominant deformation mechanism for the strain rates used in this study was found to be twinning. However, in the low strain rate range, the dislocation motion mechanism was operative at the initial deformation stage and twinning dominated the later stage of the deformation process. In the high strain rate range, the entire deformation process was dominated by twinning. The interaction between deformation twinning and grain boundaries resulted in intergranular fracture in the γ grains and delamination of α 2/γ interfaces in the lamellar colonies. |
| |
Keywords: | |
本文献已被 SpringerLink 等数据库收录! |
|