| 汽轮发电机定子强迫蒸发冷却循环流动与传热计算 |
| |
| 引用本文： | 吕玉坤,刘伟,王海红.汽轮发电机定子强迫蒸发冷却循环流动与传热计算[J].发电设备,2010,24(1):33-36. |
| |
| 作者姓名： | 吕玉坤 刘伟 王海红 |
| |
| 作者单位： | 1. 华北电力大学,能源与动力工程学院,保定,071003
2. 中国水电顾问集团西北勘测设计研究院,西安,710065 |
| |
| 摘 要： | 基于C语言编程软件和气液两相流相关理论,在忽略绕组线棒辐射散热的情况下,对汽轮发电机定子采用强迫蒸发冷却循环时的流动与传热进行了编程计算,得到了汽轮发电机定子的蒸发点、循环流量、压力和温度分布。结果表明,随着绕组线棒热负荷增加,蒸发点提前,循环流量减小,压力平衡器前的含气率增加;当含气率增加到某一临界值时,可能造成危险工况,因此必须通过计算确定临界热负荷。
|
| 关 键 词： | 发电机 蒸发冷却 蒸发点 循环流量 临界热负荷 |
Circulating Flow and Heat Transfer Calculation for Forced Evaporative Cooling System of Turbine-Generator Stators |
| |
| L Yu-kun,LIU Wei,WANG Hai-hong.Circulating Flow and Heat Transfer Calculation for Forced Evaporative Cooling System of Turbine-Generator Stators[J].Power Equipment,2010,24(1):33-36. |
| |
| Authors: | L Yu-kun LIU Wei WANG Hai-hong |
| |
| Affiliation: | 1.School of Energy and Power Engineering;North China Electric Power University;Baoding 071003;China;2.HydroChina Xibei Engineering Corporation;Xi'an 710065;China |
| |
| Abstract: | Based on theories of C language programming software and gas-liquid two-phase flow,and without consideration of heat radiation from winding bar,circulating flow and heat transfer calculation were respectively performed by computer programs for forced evaporative cooling system of a turbine-generator stator,during which the evaporation point,circulating flow rate,pressure and temperature distribution curves were obtained.Results show that with the rise of heat load on winding bar,the evaporation point will m... |
| |
| Keywords: | generator evaporation and cooling evaporation point circulating flow critical heat load |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
