| 气门调整盘塑性成形工艺 |
| |
| 引用本文： | 张雪冬,赵臣俊,李志广,胡丰泽. 气门调整盘塑性成形工艺[J]. 柴油机, 2005, 27(3): 33-35 |
| |
| 作者姓名： | 张雪冬 赵臣俊 李志广 胡丰泽 |
| |
| 作者单位： | 山西柴油机厂,山西,大同,037036;驻山西柴油机厂军代表室,山西,大同,037036 |
| |
| 摘 要： | 介绍了气门调整盘锻件的4种塑性成形工艺方案,分析了它们的优缺点,并着重分析了其中两种优化工艺方案模具的设计要点。
|
| 关 键 词： | 气门调整盘 塑性成形工艺 成组模具 优化方案 |
| 文章编号： | 1001-4357(2005)03-0033-03 |
| 收稿时间： | 2005-03-29 |
Plastic Shaping Technology of Valve Regulation Plane |
| |
| Zhang Xuedong,ZHAO Chenjun,LI Zhiguang,HU Fengze. Plastic Shaping Technology of Valve Regulation Plane[J]. Diesel Engine, 2005, 27(3): 33-35 |
| |
| Authors: | Zhang Xuedong ZHAO Chenjun LI Zhiguang HU Fengze |
| |
| Abstract: | Introduction is given to four kinds of plastic shaping technology schemes for valve regulation plate forge pieces. Their advantages and weakness are analyzed here respectively. Among those, the design gist for the dies of two kinds of optimum technology schemes are discussed. |
| |
| Keywords: | valve regulation plate plastic shaping technology group die optimum scheme |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
