| 污水源热泵系统中多级淋激式换热器的设计与分析 |
| |
| 引用本文： | 姚杨,宋艳,那威. 污水源热泵系统中多级淋激式换热器的设计与分析[J]. 暖通空调, 2007, 37(3): 63-67 |
| |
| 作者姓名： | 姚杨 宋艳 那威 |
| |
| 作者单位： | 哈尔滨工业大学,150090;哈尔滨工业大学,150090;哈尔滨工业大学,150090 |
| |
| 摘 要： | 根据哈尔滨某制药厂的污水情况，在污水源热泵系统中采用多级淋激式换热器作为污水侧换热器。采用分区参数法将换热器按制冷剂状态分为过热、两相、过冷三区，分别计算了各区的换热温差、传热系数等。分析了结构参数变化对换热器性能的影响，从而合理地设定了管列数、管径和管长，详细设计出三级淋激式换热器的结构。
|
| 关 键 词： | 污水源热泵系统 淋激式换热器 结构参数 |
| 修稿时间： | 2005-05-092005-12-07 |
Design and analysis of multistage spray heat exchangers in sewage-source heat pump systems |
| |
| Yao Yang,Song Yan,Na Wei. Design and analysis of multistage spray heat exchangers in sewage-source heat pump systems[J]. Journal Heating Ventilating and Airconditioning, 2007, 37(3): 63-67 |
| |
| Authors: | Yao Yang Song Yan Na Wei |
| |
| Affiliation: | Harbin Institute of Technology, Harbin, China |
| |
| Abstract: | According to the status of sewage in a pharmaceutical factory in Harbin, uses the multistage spray heat exchanger in the sewage-source heat pump system. Based on the refrigerant state, divides a heat exchanger into three zones with zoned lump method, i.e. superheat, two-phase and subcooling zones, works out the temperature difference and heat transfer coefficients of the three zones. Discusses the influence of structural parameters on the heat exchanger performance in order to get more rational setting of the number of columns, diameter and length of tubes, and designs the three stage spray heat exchanger in detail. |
| |
| Keywords: | sewage-source heat pump system spray heat exchanger structural parameter |
| 本文献已被 维普 万方数据 等数据库收录！ |
|
