| 基于ObjectARX的普通悬挂输送村牵引链条的张力计算 |
| |
| 引用本文： | 潘俊 楼佩煌. 基于ObjectARX的普通悬挂输送村牵引链条的张力计算[J]. 中国制造业信息化, 2007, 36(4): 38-41,45 |
| |
| 作者姓名： | 潘俊 楼佩煌 |
| |
| 作者单位： | 南京航空航天大学机电学院,江苏南京210016 |
| |
| 摘 要： | 利用AutoCAD面向对象的二次开发工具ObjectARX，并借助于Visual C＋＋6．0的开发平台，在AutoCAD2000环境下实现了悬挂输送机牵引链条的受力分析计算，同时得出链条上最大、最小受力点的大小和位置，拉紧装置的质量以及驱动电机所需的功率等。
|
| 关 键 词： | ObjcetARX 输送链 AutoCAD |
| 文章编号： | 1672-1616（2007）07-0038-04 |
| 修稿时间： | 2006-10-08 |
The Strain Analyses on Pulling Chain of Underslung Conveyor Based on ObjectARX |
| |
| PAN Jun, LOU Pei- huang. The Strain Analyses on Pulling Chain of Underslung Conveyor Based on ObjectARX[J]. Manufacture Information Engineering of China, 2007, 36(4): 38-41,45 |
| |
| Authors: | PAN Jun LOU Pei- huang |
| |
| Abstract: | It illustrates the strain calculations for pulling chain of underslung conveyor. Using ObjectARX and Visual C++6.0, it develops this analysis tool in AutoCAD2000, which can find the value and position of points at condition of the maximal and minimum strain of pulling strain, weight of the tightening device and the power demanded of the driving engine. |
| |
| Keywords: | ObjcetARX Conveyor Chain AutoCAD |
| 本文献已被 CNKI 维普 等数据库收录！ |
