Ti-3.0Al-3.7Cr-2.0Fe-0.1B钛合金的热压缩行为(英文)

利用Gleeble-1500D热模拟试验机对低成本钛合金Ti-3.0Al-3.7Cr-2.0Fe-0.1B的热压缩行为进行研究。采用的应变速率分别为0.01、0.1、1.0和10s1,选用的温度分别为800、850、900和950°C,试样的变形量最大为70%。结果表明:峰值流变应力随着温度的增加和应变速率的降低而降低;根据Arrhenius公式获得该合金在本实验条件下的本构方程为ε=6.1×1012[sinh(0.0113044σ)]3.35×exp(-261719.8/RT),并得到了该合金的加工图。当应变速率大于等于1.0s1时,合金内发生动态再结晶现象,且应变速率越大动态再结晶现象越明显。

Hot compressive behavior of Ti-3.0Al-3.7Cr-2.0Fe-0.1B titanium alloy

The hot deformation behavior of Ti-3.0Al-3.7Cr-2.0Fe-0.1B (TACFB) titanium alloy was investigated using a Gleeble-1500D thermal simulator in the temperature range of 800-950 °C, at constant strain rate from 0.01 s-1 to 10 s-1 and with height reduction of 70%. Flow stress and microstructure evolution during hot compression of TACFB alloy were investigated. The processing map of TACFB alloy was obtained. The results indicate that the hot deformation behavior of TACFB alloy is sensitive to the deformation temperature and strain rate. The peak flow stress decreases with increasing the test temperature and decreasing the strain rate. The constitutive relationship of TACFB alloy was obtained on the base of Arrhenius equations. When the strain rates are higher than 1.0 s-1, the dynamic recrystallization occurs, and the higher the strain rates are, the more the recrystallization is.