| 冲入法与喂线法球化处理工艺对比 |
| |
| 引用本文： | 姚成方,李明,张行河,房夺. 冲入法与喂线法球化处理工艺对比[J]. 现代铸铁, 2011, 0(4): 29-31. DOI: 10.3969/j.issn.1003-8345.2011.04.003 |
| |
| 作者姓名： | 姚成方 李明 张行河 房夺 |
| |
| 作者单位： | 潍柴动力股份有限公司技术中心,山东潍坊,261001 |
| |
| 摘 要： | 采用冲入法和喂线法两种球化处理工艺生产QT600-3凸轮轴,对比其成分、组织和性能,结果表明：用喂线法生产的铸件,w（S残）量达到双零级、w（Mg残）量的波动亦小,且球化效果好（石墨球数量多、尺寸小、圆整度高、球化率高）,力学性能良好稳定。
|
| 关 键 词： | 球墨铸铁 冲入法 喂线法 球化处理工艺 |
Nodularization Comparison between Pour-Over Process and Cored Wire Injection Process |
| |
| YAO Cheng-fang,LI Ming,ZHANG Xing-he,FANG Duo. Nodularization Comparison between Pour-Over Process and Cored Wire Injection Process[J]. Modern Cast Iron, 2011, 0(4): 29-31. DOI: 10.3969/j.issn.1003-8345.2011.04.003 |
| |
| Authors: | YAO Cheng-fang LI Ming ZHANG Xing-he FANG Duo |
| |
| Affiliation: | YAO Cheng-fang,LI Ming,ZHANG Xing-he,FANG Duo (Technology Center,Weifang Diesel Engine Power Co. Ltd.,Weifang 261001,China) |
| |
| Abstract: | Nodular iron camshafts of QT600-3 grade were produced with pour-over nodularizing process and cored wire injection process, their chemical composations, microstructures and properties were compared. The result showed that, for the nodular iron produced with cored wire injection process, the residual S content was relatively lower reaching the order of magnitude of 10-5, fluctuation range of the residual Mg content was also narrow; nodularity and nodule count of castings was relatively higher, graphite size ... |
| |
| Keywords: | nodular iron pour-over process cored wire injection process nodularization process |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
