| 关于双角钢十字组合型截面的填板设计方法探讨 |
| |
| 引用本文： | 石鹿言,李振宝,杨小强,高志升.关于双角钢十字组合型截面的填板设计方法探讨[J].工业建筑,2011(Z1):365-367,312. |
| |
| 作者姓名： | 石鹿言 李振宝 杨小强 高志升 |
| |
| 作者单位： | 北京工业大学工程抗震与结构诊治北京市重点实验室;北京市市政专业设计院; |
| |
| 摘 要： | 铁塔中实腹式组合角钢构件在两节点间需设置填板,在DL/T 5154-2002《架空送电线路杆结构设计技术规定》、GB 50017-2003《钢结构设计规范》中,仅简要提出了填板设置的构造要求,而对填板及其连接螺栓的设计计算、具体布置方式均未作详细说明,设计时往往根据经验进行设计。采用试验研究和有限元分析两种方法,通过填板位置和方向的不同来研究填板在组合角钢中所起的作用,以探索填板的设计方法。
|
| 关 键 词： | 组合型截面 填板 轴心受压 |
RESEARCH ON METHOD OF PLATE DESIGNING WITH DUAL-ANGLE STEEL COMBINED SECTION |
| |
| Shi Luyan Li Zhenbao Yang Xiaoqiang Gao Zhisheng.RESEARCH ON METHOD OF PLATE DESIGNING WITH DUAL-ANGLE STEEL COMBINED SECTION[J].Industrial Construction,2011(Z1):365-367,312. |
| |
| Authors: | Shi Luyan Li Zhenbao Yang Xiaoqiang Gao Zhisheng |
| |
| Affiliation: | Shi Luyan1 Li Zhenbao1 Yang Xiaoqiang1 Gao Zhisheng2(1.Beijing Key Lab of Earthquake Engineer and Structural Retrofit,Beijing University of Technology,Beijing 100124,China,2.Beijing Municipal Engineering Professional Design Institute,Beijing 100037,China) |
| |
| Abstract: | Assembly angle iron with solid member need set plates between two nodes in the steel tower.Only some construction requirement about setting plates is put forward in current standard such as: Aerial Transmission Line Road Post Tower Structure Design(DL/T 5154-2003) and Design Code for the Steel Structures(GB 50017-2003),but these standards haven't given any specify about design calculation of the plates and connecting bolts,and also the specific arrangement mode,so the design is often based on the experience... |
| |
| Keywords: | combined section plates axial compression |
| 本文献已被 CNKI 等数据库收录！ |
|
