| Abstract: | In the past, increased attention was given to the development of an optimal shape for the inlet part of LP turbine casings in SKODA POWER. A double-flow design is typically used for high power output turbines. An optimized shape for the internal diffuser has been found, which transforms the kinetic energy of steam into increased pressure, thus effectively increasing the thermodynamic efficiency of the stage. Some conclusions have been drawn from laboratory experiments, others derived directly from on-site measurements at power plants. The conclusions from the development of double-flow turbines form the basis for the design of the single-flow turbine arrangement. Single-flow design is typically used for lower output turbines. There are still some limitations in applying this arrangement. The designer needs to resolve the bearing position and how to ensure access to them. Reinforcing the ribs and supports are used, therefore, to ensure the rigidity of the entire casing. The optimization of the single-flow diffuser shape is therefore the subject of the study presented below. |
